The heated steering wheel control module controls the heated steering wheel and the heated steering wheel ON indicator based on an input from the heated steering wheel switch. When the heated steering wheel switch is pressed, the switch signal circuit is pulled to ground. This indicates to the heating steering wheel control module that steering wheel heat is requested. When the request is seen, the heated steering module supplies voltage to the indicator lamp and supplies voltage to the heating elements, which are internal to the steering wheel.

Schematic Reference

Steering Wheel Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Steering Wheel and Column Description and Operation

Electrical Information Reference

Ignition ON, press and release the heated steering wheel switch. The heated steering wheel indicator should illuminate and the left and right sides of the steering wheel should become warm.

1. Ignition OFF, disconnect the harness connector at the heated steering wheel control module.
2. Test for less than 5.0 ohms between the ground circuit terminal B X1 and ground.

⇒	If greater than the specified value, test the ground circuit for an open/high resistance.

3. Ignition ON, verify a test lamp illuminates between the ignition voltage circuit terminal A X1 and ground.

⇒	If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.

4. Install a 3A fused jumper wire between the control circuit terminal A X2 and B+. Verify the heated steering wheel indicator is illuminated.

⇒	If the indicator does not illuminate, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, test or replace the left steering wheel control switch.

5. Verify that a test lamp does not illuminate between the indicator control circuit terminal A X2 and ground.

⇒	If the test lamp is always ON, test the indicator control circuit for a short to voltage. If the circuit tests normal, replace the heated steering wheel control module.

6. If all circuits test normal, replace the heated steering wheel control module.

Heated Steering Wheel Control Switch

1. Place the heated steering wheel control switch in the OFF position.
2. Test for infinite resistance between terminal 4 and terminal 5.

⇒	If less than the specified value, replace the switch.

3. Place the heated steering wheel control switch in the ON position.
4. Test for less than 2 ohms between terminal 4 and terminal 5.

⇒	If greater than the specified value, replace the switch.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.