Removal Procedure
- Remove the steering wheel. Refer to
Steering Wheel Replacement
.
- Remove the ignition lock cylinder. Refer to
Ignition Lock Cylinder Replacement
.
- Disconnect any electrical connectors as needed.
- Remove the steering column lower trim cover bolts (2).
- Remove the steering column lower trim cover (1).
- Remove the steering column upper trim cover bolt (2).
- Remove the steering column upper trim cover (2).
- Transfer any parts as needed.
Installation Procedure
- Install the steering column upper trim cover (1) to the steering column.
Notice: Refer to Fastener Notice in the Preface section.
- Install the steering column upper trim cover bolt (2).
Tighten
Tighten the bolt to 1 N·m (9 lb in).
- Install the steering column lower trim cover (1).
- Remove the steering column lower trim cover bolts (2).
Tighten
• | Tighten the bolt nearest tilt lever to 3.5 N·m (31 lb in). |
• | Tighten the bolt in center of cover to 1.6 N·m (14 lb in). |
- Connect any electrical connectors as needed.
- Install the ignition lock cylinder. Refer to
Ignition Lock Cylinder Replacement
.
- Install the steering wheel. Refer to
Steering Wheel Replacement
.