Removal Procedure
- Remove the center and front sunroof windows. Refer to
Sunroof Window Replacement
.
- Disconnect the motor/actuator electrical harness from either the front (6) or rear (2) sunshade motor/actuator being serviced.
- Remove the motor/actuator to motor/actuator block screws.
- Pull the sunroof motor/actuator up. The motor/actuator may need to be rocked side-to-side in order to release the sunshade motor/actuator drive gear from the cables.
- Remove the sunshade motor/actuator.
Installation Procedure
- Pull the shade completely closed against the sunshade stops (3).
- Inspect the gap of the shade's extended edge to the sunroof frame for even spacing.
Notice: Refer to Fastener Notice in the Preface section.
- Install the motor/actuator and screws.
Tighten
Tighten the screws to 5 N·m (44 lb in).
- Connect the motor/actuator electrical harness to either the front (6) or rear (2) sunshade motor/actuator.
- Install the center and front sunroof windows. Refer to
Sunroof Window Replacement
.
- Perform the sunshade initialization procedure. Refer to
Sunroof Front Window/Sunshade Initialization Process
or
Sunroof Rear Window Initialization Process
.