Instrument Panel Outer Air Outlet Upper Duct Replacement - Right Side Left Hand Drive

1. Remove the instrument panel (I/P) retainer. Refer to Instrument Panel Retainer Replacement .



2. Remove the dash insulator (1).



3. Disconnect the wiring harness from the air duct (1).



4. Remove the screws (1) that retain the air duct (2).
5. Remove the right air duct (2), by releasing the tabs from the module.

1. Install the right air duct (2), by pressing down until you hear the tabs engage on the HVAC module .

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the right air duct screws (1).

Tighten
Tighten the screws to 2 N·m (18 lb in).




3. Connect the wiring harness to the air duct (1).



4. Install the dash insulator (1).
5. Install the I/P retainer. Refer to Instrument Panel Retainer Replacement .

Instrument Panel Outer Air Outlet Upper Duct Replacement - Right Side Right Hand Drive

1. Remove the instrument panel (I/P) retainer. Refer to Instrument Panel Retainer Replacement .



2. Disconnect the wiring harness from the air duct (1).



3. Remove the screws (1) that retain the air duct (2).
4. Remove the right air duct (2), by releasing the tabs from the module.

1. Install the right air duct (2), by pressing down until you hear the tabs engage on the HVAC module .

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the right air duct screws (1).

Tighten
Tighten the screws to 2 N·m (18 lb in).




3. Connect the wiring harness to the air duct (1).
4. Install the I/P retainer. Refer to Instrument Panel Retainer Replacement .