Blower Motor Replacement Left Hand Drive

1. Remove the right closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side .
2. Remove the instrument panel (I/P) compartment. Refer to Instrument Panel Compartment Replacement .



3. Disconnect the blower motor electrical connector.



4. Disconnect the blower motor processor electrical connector.



5. Remove the screws (1) that retain the blower motor.



6. Remove the blower motor.

1. Install the blower motor.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the blower motor screws (1).

Tighten
Tighten the screws to 1.5 N·m (13 lb in).




3. Connect the blower motor processor electrical connector.



4. Connect the blower motor electrical connector.
5. Install the I/P compartment. Refer to Instrument Panel Compartment Replacement .
6. Install the right closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side .

Blower Motor Replacement Right Hand Drive

1. Remove the left closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
2. Remove the instrument panel (I/P) compartment. Refer to Instrument Panel Compartment Replacement .



3. Disconnect the blower motor electrical connector.



4. Disconnect the blower motor processor electrical connector.



5. Remove the screws (1) that retain the blower motor.



6. Remove the blower motor.

1. Install the blower motor.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the blower motor screws (1).

Tighten
Tighten the screws to 1.5 N·m (13 lb in).




3. Connect the blower motor processor electrical connector.



4. Connect the blower motor electrical connector.
5. Install the I/P compartment. Refer to Instrument Panel Compartment Replacement .
6. Install the left insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .