Removal Procedure
Caution: Refer to SIR Caution in the Preface section.
- Disable the SIR system. Refer to
SIR Disabling and Enabling
.
- Remove the upper and lower trim covers. Refer to
Steering Column Trim Covers Replacement
.
- Remove the theft deterrent control module (2) from the ignition lock cylinder case (1).
- Disconnect the connector located by the ignition switch.
- Remove the 2 tapping screws (2) from the ignition switch assembly (1).
- Remove the ignition switch (1) from the ignition lock cylinder case.
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
- Install the ignition switch (1) and secure by using the 2 tapping screws (2).
Tighten
Tighten the screws to 7 N·m (62 lb in).
- Connect the connector to the ignition switch.
- Install the theft deterrent control module (2) onto the ignition lock cylinder case (1).
- Install the upper and lower trim covers. Refer to
Steering Column Trim Covers Replacement
.
- Enable the SIR system. Refer to
SIR Disabling and Enabling
.