GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
Cadillac
🢒
2008
🢒
SRX
🢒
Preface
🢒
Cautions and Notices
🢒 Steering Column Tilt Head Replacement
Tools Required
J 21854-01
Pivot Pin Remover
Removal Procedure
Remove the steering column. Refer to
Steering Column Replacement
.
Remove the turn signal multifunction switch. Refer to
Turn Signal Multifunction Switch Replacement
.
Remove the tilt spring. Refer to
Steering Column Tilt Spring Replacement
.
Remove the ignition lock cylinder case. Refer to
Ignition Lock Cylinder Case Replacement
.
Remove the steering column pivot pins (3) from the steering column tilt head (1) using remover
J 21854-01
(2) .
Install the tilt lever into the steering column tilt head (1).
Pull back on the tilt lever and disengage the steering column tilt head (1) with the steering shaft (3) connected from the steering column jacket (2)
Remove the steering shaft (1) from the steering column tilt head.
Installation Procedure
Install the steering shaft (1) into the steering column tilt head assembly.
Install the steering column tilt head (1) and attached steering shaft (3) into the steering column jacket (2).
Align the steering column tilt head with the steering column pivot pin holes on the steering column jacket.
Lubricate the steering column pivot pins with GM P/N 12346293 (Canadian P/N 99723) and install them into the steering column tilt head.
Stake each steering column pivot pin in 3 places.
Install the ignition lock cylinder case. Refer to
Ignition Lock Cylinder Case Replacement
.
Install the tilt spring. Refer to
Steering Column Tilt Spring Replacement
.
Install the turn signal multifunction switch. Refer to
Turn Signal Multifunction Switch Replacement
.
Install the steering column. Refer to
Steering Column Replacement
.