GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2008 🢒 SRX 🢒 General Information 🢒 General Information 🢒 Shift Control Linkage Adjustment

Shift Control Linkage Adjustment All Wheel Drive

  1. Position the shift lever in PARK.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.

    3. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1827763 Size: SH
  3. Loosen the shift control linkage adjustment nut to allow the adjuster to slide freely.
  4. Hold the selector lever on transmission against the rear stop to eliminate any play.

    5. Tighten
    Tighten the shift control linkage adjustment nut to 9 N·m (80 lb in).

  5. Lower the vehicle.

    6. Object Number: 1828166 Size: SH
  6. Inspect the operation of the starting system with the shift lever in each position. The engine should only crank when the lever is in the PARK or NEUTRAL position.
  7. If the key is stuck or hard to remove from the lock cylinder or there is a high button effort, the linkage may not be adjusted properly. Re-adjust as necessary.
  8. Ensure that the shifter detents align with the gear indicators.
  9. Return to the PARK position and check for proper engagement. PARK position should feel solid and not spongy. The shift lever should not be bottomed out on the stop bumper when engaging the PARK position. Readjust and retest if necessary.
  10. With the ignition on and the engine not running, ensure a smooth transition from position D to tap mode and back. Ensure that the odometer changes to the gear indicator mode. If the odometer does not change to gear indicator mode, or any binding or rough spots are felt, repeat the linkage adjustment procedure and retest the system.

Shift Control Linkage Adjustment Rear Wheel Drive

  1. Position the shift lever in PARK.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.

    3. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1841190 Size: SH
  3. Loosen the shift control linkage adjustment nut to allow the adjuster to slide freely.
  4. Hold the selector lever on transmission against the rear stop to eliminate any play.

    5. Tighten
    Tighten the shift control linkage adjustment nut to 9 N·m (80 lb in).

  5. Lower the vehicle.

    6. Object Number: 1841188 Size: SH
  6. Inspect the operation of the starting system with the shift lever in each position. The engine should only crank when the lever is in the PARK or NEUTRAL position.
  7. If the key is stuck or hard to remove from the lock cylinder or there is a high button effort, the linkage may not be adjusted properly. Re-adjust as necessary.
  8. Ensure that the shifter detents align with the gear indicators.
  9. Return to the PARK position and check for proper engagement. PARK position should feel solid and not spongy. The shift lever should not be bottomed out on the stop bumper when engaging the PARK position. Readjust and retest if necessary.
  10. With the ignition on and the engine not running, ensure a smooth transition from position D to tap mode and back. Ensure that the odometer changes to the gear indicator mode. If the odometer does not change to gear indicator mode, or any binding or rough spots are felt, repeat the linkage adjustment procedure and retest the system.