Diagnostic Instructions
DTC Descriptor
DTC C0252: VSES Sensors Uncorrelated
Circuit/System Description
The vehicle stability enhancement system (VSES) is activated by the electronic brake control module (EBCM) calculating the desired yaw rate and comparing it to the actual yaw rate input. The desired yaw rate is calculated from measured steering
wheel position, vehicle speed, and lateral acceleration. The difference between the desired yaw rate and actual yaw rate is the yaw rate error, which is a measurement of oversteer or understeer. If the yaw rate error becomes too large, the EBCM will attempt
to correct the vehicles yaw motion by applying differential braking to the left or right front wheel.
The amount of differential braking applied to the left or right front wheel is based on both the yaw rate error and side slip rate error. The side slip rate error is a function of the lateral acceleration minus the product of the yaw rate and vehicle speed.
The yaw rate error and side slip rate error are combined to produce the total delta velocity error. When the delta velocity error becomes too large and the VSES system activates, the drivers steering inputs combined with the differential braking will attempt
to bring the delta velocity error toward zero.
Conditions for Running the DTC
| • | The steer angle has been centered. |
| • | The direction, understeer or oversteer, of the yaw rate error has not changed. |
| • | The centered lateral acceleration value is less than 0.5 g (0.02 oz). |
| • | The yaw rate error is less than 6 degrees/second. |
| • | The side slip error is greater than 1.8 meters/second². |
Conditions for Setting the DTC
One of the following conditions exists:
| • | The yaw rate error is greater than 10 degrees/second with the vehicle speed less than 60 km/h (37 mph) and the acceleration pedal is pressed more than 25 percent of the pedal travel range for 1 second during the
VSES activation. |
| • | With the yaw rate less than 8 degrees/second, the side slip error is greater than 4.9 meters/second² for 5 seconds. |
Action Taken When the DTC Sets
| • | The EBCM disables the VSES for the duration of the ignition cycle. |
| • | The vehicle dynamics caution (VDC) indicator illuminates. |
| • | The driver information center (DIC) displays the SERVICE STABILITRAK message. |
| • | The antilock brake system (ABS) and traction control system (TCS) remains functional. |
Conditions for Clearing the DTC
| • | The condition for the DTC is no longer present and the DTC is cleared with a scan tool. |
| • | The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Diagnostic Aids
The following conditions can cause this concern:
| • | Improper steering alignment |
| • | Open, short to ground, or short to voltage |
| • | Internal yaw rate/lateral accelerometer sensor failure |
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
ABS Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References
for Scan Tool Information
Circuit/System Verification
- With the scan tool perform the Steering Angle Sensor Calibration.
- Operate the vehicle within the conditions for setting the DTC. Verify DTC C0186, C0196,C0252, or C0710 are not set.
| ⇒ | If DTC C0252 is set, replace the yaw and lateral acceleration sensor. If DTC C0252 sets again, replace the EBCM. |
Repair Instructions
Perform the
Diagnostic Repair Verification
after completing the diagnostic procedure.
