Removal Procedure
- Remove the fuel injector sight shield. Refer to
Fuel Injector Sight Shield Replacement.
Note: When disconnecting more than one sensor, mark the connectors to ensure correct installation. The electrical connectors are physically interchangeable, however, they must be installed to the correct sensor.
- Disconnect the electrical connector from the left bank exhaust camshaft position sensor (2).
- Remove the camshaft sensor retaining bolt.
- Remove the left bank exhaust camshaft sensor (4).
Installation Procedure
Note: Inspect the camshaft sensor O-ring for wear or damage. If a condition is found, replace the O-ring.
- Lubricate the camshaft sensor O-ring with engine oil.
Caution: Refer to Fastener Caution in the Preface section.
- Install the left bank exhaust camshaft position sensor (4) and retaining bolt and tighten to
10 N·m (89 lb in).
- Reconnect the camshaft sensor electrical connector (2).
- Install the fuel injector sight shield. Refer to
Fuel Injector Sight Shield Replacement.
- Operate the engine and inspect the camshaft sensor for engine oil leaks.