GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2009 🢒 SRX 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Brake and Accelerator Pedal Adjuster Switch Replacement

Removal Procedure

    Warning: Refer to SIR Warning in the Preface section.


    Object Number: 312312 Size: SH
  1. Disable the SIR system. Refer to SIR Disabling and Enabling.
  2. Disconnect the adjuster pedal switch connector at the base of the steering column.
  3. Remove the wire harness straps from the wire harness assembly.
  4. Remove the adjuster pedal switch lead from the wire harness assembly.
  5. Remove the 2 pan head tapping screws (2) from the lower trim cover (1).
  6. Remove the lower trim cover (2).

    7. Object Number: 312321 Size: SH
  7. Remove the adjuster pedal switch assembly (2) from the lower trim cover (1).

    8. Object Number: 332857 Size: SH
  8. Remove the TORX® head screw (2) from the upper trim cover (1).
  9. Remove the upper trim cover (1).

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 312325 Size: SH
  1. Install the upper trim cover (1) and secure by using the TORX® head screw (2).

    2. Tighten
    Tighten the screws to 1.5 N·m (13 lb in).


    Object Number: 312321 Size: SH
  2. Install the adjuster pedal switch assembly (2) into the lower trim cover (1).

    3. Object Number: 312312 Size: SH
  3. Install the lower trim cover (1).
  4. Install the 2 pan head tapping screws (2) into the lower trim cover (1).

    5. Tighten
    Tighten the screws to 3.5  N·m (31 lb in).

  5. Route the adjuster pedal switch lead into the wire harness assembly.
  6. Install the wire harness straps onto the wire harness assembly.
  7. Connect the adjuster pedal switch connector at the base of the steering column.
  8. Enable the SIR system. Refer to SIR Disabling and Enabling.