The cruise control switch contains an LED that illuminates to indicate the cruise control system has been switched ON. Voltage is applied through the ON/OFF switch to the LED when the switch is pressed. Pressing the switch again opens the switch and the lamp turns OFF. The body control module (BCM) monitors the cruise control indicator switch.

Schematic Reference

Cruise Control Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Cruise Control Description and Operation

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

Ignition ON, observe the scan tool Cruise Control Switch parameter. Verify the parameter changes each time the switch is pressed.

Important: Refer to DTC B3794 before performing this diagnostic, if this code is set as current or history.

1. Ignition OFF, disconnect the harness connector at the steering wheel control switch-left.
2. Ignition ON, verify that a test lamp illuminates between the low reference circuit terminal 7 and B+.

⇒	If the test lamp does not illuminate, test the low reference circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.

3. If all circuits test normal, test or replace the steering wheel controls switch-left.

1. Disconnect the harness connector at the steering wheel controls switch - left.
2. Cruise control switch ON, measure the resistance between terminal 1 and terminal 2 while individually activating and holding each cruise control function switch and compare the resistance reading to the values in the table below.

⇒	If not within the specified resistance range, replace the steering wheel controls switch - left.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.