GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
Cadillac
🢒
2009
🢒
SRX
🢒
Diagnostic Navigation
🢒
Vehicle Diagnostic Information
🢒 Shock Absorber Replacement
Removal Procedure
Remove the trim panel.
Move the sound insulator away from the shock tower.
Disconnect the electrical connector (1) for the F55 suspension, if equipped.
Remove the upper shock mounting nuts (2).
Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
Disconnect the automatic level control air line from the shock for F55 suspension, if needed.
Remove the lower shock mounting bolt.
Remove the shock from the vehicle.
Installation Procedure
Install the shock to the vehicle.
Caution:
Refer to
Fastener Caution
in the Preface section.
Install the lower shock mounting bolt and tighten to
150 N·m (111 lb ft)
.
Connect the automatic level control air line to the shock for the F55 suspension, if needed.
Guide the shock to the body while lowering the vehicle.
Install the upper shock mounting nuts (2) and tighten to
25 N·m (18 lb ft)
.
Connect the electrical connector (1) for the F55 suspension, if needed.
Reposition the sound insulator around the shock tower.
Install the trim panel.