Removal Procedure
- Remove the door trim panel. Refer to
Front Side Door Trim Panel Replacement.
- Disconnect the power mirror wire harness electrical connector (3).
- Remove the mirror fasteners (4, 5, 6).
- Remove the mirror (1) from the door.
- Pull the wiring harness through the hole in the mirror patch.
Installation Procedure
- Route the mirror wiring harness through the hole in the mirror patch.
- Seat the grommet (2) into the hole in the door frame.
- Install the mirror (1) into the door frame.
Caution: Refer to Fastener Caution in the Preface section.
- Install the mirror fasteners in the following sequence:
Tighten
- Tighten the top mirror fastener (4) to 9 N·m (80 lb in).
- Tighten the forward mirror fastener (5) to 9 N·m (80 lb in).
- Tighten the rear, lower mirror fastener (6) to 9 N·m (80 lb in).
- Connect the power mirror electrical connector (3).
- Install the door trim panel. Refer to
Front Side Door Trim Panel Replacement.