GM Service Manual Online
For 1990-2009 cars only

Inside Rearview Mirror Replacement DD7 , DD8


Object Number: 2000287  Size: MF

Callout

Component Name

1

Inside Rearview Mirror

Caution: Refer to Fastener Caution in the Preface section.

Procedure

  1. Remove the inside rearview mirror cover, if equipped.
  2. Disconnect the electrical connector, if equipped.
  3. Adjust the mirror to the full upward position.
  4. Loosen the set screw located at the base of the mirror.
  5. Slide the mirror upward off of the rearview mirror button.
  6. Remove the windshield outside moisture sensor, if equipped.
  7. Refer to Control Module References for programming and setup information, if equipped.

Tighten
2 N·m (18 lb in)

Inside Rearview Mirror Replacement UE1

Removal Procedure


    Object Number: 787027  Size: SH
  1. Disconnect the electrical connector from the back of the mirror.
  2. Remove the wire cover.
  3. Adjust the mirror to the full upward position.
  4. Remove the base trim cover.

  5. Object Number: 787028  Size: SH
  6. Loosen the screw (3) in order to remove the mirror (2) from the button assembly (1).
  7. Slide the mirror assembly in an upward motion in order to remove.

Installation Procedure


    Object Number: 787028  Size: SH
  1. Position the center bottom of the mirror mount against the windshield at the top of the support button (1).
  2. Slide the base of the mirror onto the button.
  3. Caution: Refer to Fastener Caution in the Preface section.

  4. Make sure the mirror is firmly seated on the windshield button by pushing down on the base of the mirror.
  5. Tighten
    Tighten the screw (3) to 1.8 N·m (16 lb in) in order to secure the mirror base to the button.

  6. Install the base trim cover.

  7. Object Number: 787027  Size: SH
  8. Connect the electrical connector.
  9. Install the wire cover.
  10. Reposition the mirror assembly.