Removal Procedure
Note: Do not swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock, "XM Theftlock" will be displayed.
- Remove the right body side trim. Refer to
Body Side Rear Trim Panel Replacement.
- Remove the fasteners securing the digital radio receiver.
- Disconnect the electrical connectors.
- Remove the receiver.
Installation Procedure
- Connect the receiver electrical connectors.
- Locate the receiver to the vehicle.
Caution: Refer to Fastener Caution in the Preface section.
- Install the fasteners securing the receiver to the vehicle.
Tighten
Tighten the fasteners to 9 N·m (80 lb in).
- Install the right body side trim. Refer to
Body Side Rear Trim Panel Replacement.
- For programming and setup. Refer to
Control Module References.