- Loosen the door hinge to pillar bolts. This will allow adjustment of the door at the hinge pillar in the following directions:
• | Up or down (c), 0.0-2.0 mm (0.0 - 0.08 in) upwards, 1 mm (0.04 in) upwards preferred. |
• | Fore or aft (b), 3 -- 5 mm (0.12 -- 0.20 in) equal gap, 4 mm (0.16 in) preferred. |
- Reposition the door as needed.
Caution: Refer to Fastener Caution in the Preface section.
- Position the door fore or aft at the hinge pillar attachment. Perform the following steps as needed:
3.2. | Reposition the door. |
Tighten
Tighten the bolts to 25 N·m (18 lb ft).
- Verify the doors are flush to within 1 mm (0.04 in), with a flushing magnet (1) located in the striker area below the beltline.
- If in or out adjustment is needed, remove the door hinge. Refer to
Front Side Door Hinge Replacement or
Rear Side Door Hinge Replacement.
- Drill the door side of the hinge holes with a 13 mm (0.5 in) drill bit in order to allow for 2.5 mm (0.10 in) in or out adjustment.
- Use replacement bolts, GM P/N 11519454 on the door side of the hinge.
- Leave the bolts on the door side of the hinge loose.
- Align the front door to the front fender first, if needed.
- Position the door in or out. Perform the following steps as needed:
10.2. | Reposition the door. |
Tighten
Tighten the bolts to 25 N·m (18 lb ft).
- Align the rear door to the front door and rear quarter, if needed.
- Position the door in or out. Perform the following steps as needed:
12.2. | Reposition the door. |
Tighten
Tighten the bolts to 25 N·m (18 lb ft).
- Adjust the seal gap (a) at the door header to 13 -- 17 mm (0.52 -- 0.68 in), 15 mm (0.60 in) preferred, by placing knee near the beltline and pulling inward or pushing outward.
- Verify door header to door header at the center pillar is flush to within 1 mm (0.04 in). Adjust the door headers if necessary.
- Verify all door gaps are within specifications.
- Adjust the lock striker. Refer to
Door Lock Striker Adjustment.