Radio Replacement. Cadillac SRX 2009

For 1990-2009 cars only

Makes 🢒 Cadillac 🢒 2009 🢒 SRX 🢒 Power and Signal Distribution 🢒 Data Communications 🢒 Radio Replacement

Radio Replacement Right Hand Drive

Callout	Component Name
Preliminary Procedures Remove the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement. Remove the instrument panel air outlet. Refer to Instrument Panel Center Air Outlet Replacement. Remove the HVAC control module. Refer to HVAC Control Module Replacement.
1	Radio Screw (Qty: 4) Caution: Refer to Fastener Caution in the Preface section. Tighten 2.5 N·m (22 lb in)
2	Radio Assembly Procedure Disconnect the electrical connector. Disconnect the antenna cable. Reprogram the radio after replacement. Refer to Control Module References. Tip When installing the radio verify that the locator pin on the back of the radio is firmly seated in the I/P structure extension.

Callout

Component Name

Remove the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement.
Remove the instrument panel air outlet. Refer to Instrument Panel Center Air Outlet Replacement.
Remove the HVAC control module. Refer to HVAC Control Module Replacement.

Radio Screw (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
2.5 N·m (22 lb in)

Radio Assembly

Tip
When installing the radio verify that the locator pin on the back of the radio is firmly seated in the I/P structure extension.

Callout	Component Name
Preliminary Procedures Remove the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement. Remove the instrument panel air outlet. Refer to Instrument Panel Center Air Outlet Replacement. Remove the HVAC control module. Refer to HVAC Control Module Replacement.
1	Radio Screw (Qty: 4) Caution: Refer to Fastener Caution in the Preface section. Tighten 2.5 N·m (22 lb in)
2	Radio Assembly Procedure Disconnect the electrical connector. Disconnect the antenna cable. Reprogram the radio after replacement. Refer to Control Module References. Tip When installing the radio verify that the locator pin on the back of the radio is firmly seated in the I/P structure extension.