GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2009 🢒 SRX 🢒 Power and Signal Distribution 🢒 Wiring Systems and Power Management 🢒 Ignition Can/Cannot Be Turned Off with Transmission in Any Gear

Diagnostic Instructions
    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Circuit/System Description

The body control module (BCM) controls voltage to the ignition lock cylinder actuator. When the gearshift is in PARK, the park position switch is closed. This grounds the circuit allowing the lock cylinder actuator to retract the pin. This allows the ignition lock cylinder to be turned to the LOCK position. When the gearshift is not in PARK, the park position switch is open, and the spring loaded pin is in the out position. This prevents the ignition lock cylinder from being turned to LOCK.

Reference Information

Schematic Reference

    •  Power Moding Schematics
    •  Power Distribution Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Retained Accessory Power (RAP) Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information.

Circuit/System Verification
  1. Ignition OFF, disconnect the harness connector at the park switch.
  2. Ignition OFF, test for less than 5 ohms of resistance between the ground circuit and ground.
    3. ⇒If greater than the specified range, test the circuit for an open/high resistance.
  3. Ignition OFF, disconnect the harness connector at the ignition lock cylinder control actuator.
  4. Ignition ON, verify a test lamp illuminates between the control circuit terminal B and ground.
    5. ⇒If the test lamp does not illuminate, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
  5. Connect a test lamp between the control circuit terminal A and the control circuit terminal B.
  6. Ignition ON, cycle the gear shift from PARK to DRIVE. The test lamp should turn ON and OFF when cycled between gears.
    7. ⇒If the test lamp is always ON, test the control circuit for a short to ground. If circuit tests normal, replace the park switch.
    ⇒If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If circuit tests normal, replace the park switch.
  7. If all circuits test normal, replace the ignition lock cylinder control actuator.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

    •  Transmission Control Replacement
    •  Control Module References for BCM replacement, setup, and programming