GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2005 🢒 STS 🢒 Engine 🢒 Engine Mechanical - 4.6L (LH2) 🢒 Camshaft Cover Replacement - Left Side

Removal Procedure

    Object Number: 928145 Size: SH
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  2. Disconnect the positive crankcase ventilation (PCV) fresh air tube from the left camshaft cover.
  3. Remove the left side ignition module. Refer to Ignition Control Module Replacement - Bank 2 for the 4.6L (LH2) engine.

    4. Object Number: 928237 Size: SH
  4. Remove the bolt connecting the ground strap to the left camshaft cover.
  5. Remove the bolt securing the oil level indicator tube to the left cylinder head and reposition the tube away from the camshaft cover.

    6. Object Number: 928241 Size: SH
  6. Remove the camshaft cover bolts.
  7. Lift the camshaft drive end of the camshaft cover up.
  8. Remove the camshaft cover.
  9. Discard the camshaft cover gasket and spark plug port seals if there is any evidence of damage or if the seal comes out of the groove in the cover during removal.
  10. Clean the gasket mating surface on the cylinder head.
  11. Clean and inspect the camshaft cover. Refer to Camshaft Cover Cleaning and Inspection .

Installation Procedure

    Object Number: 1242782 Size: SH
  1. Install a new camshaft cover gasket to the camshaft cover if necessary.
  2. Place a small amount of sealant at the split line (1, 2) of the left cylinder head and the left camshaft position actuator housing. Refer to Adhesives, Fluids, Lubricants, and Sealers for the correct part number.

    3. Important: Be careful to prevent the exposed section of the camshaft cover gasket from being damaged by the edge of the cylinder head casting.

  3. Work the camshaft cover into position by pivoting the cover down and aligning the bolt holes.

    4. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 928241 Size: SH
  4. Install the camshaft cover bolts.

    5. Tighten
    Tighten the camshaft cover bolts to 10 N·m (89 lb in).


    Object Number: 928237 Size: SH
  5. Install the bolt connecting the left camshaft cover ground strap to the left camshaft cover.

    6. Tighten
    Tighten the left ground strap bolt to 10 N·m (89 lb in).

  6. Rotate the oil level indicator tube back into its original position and install the bolt securing the tube to the cylinder head.

    7. Tighten
    Tighten the oil level indicator tube bolt to 10 N·m (89 lb in).


    Object Number: 928145 Size: SH
  7. Install the ignition module. Refer to Ignition Control Module Replacement - Bank 2 for the 4.6L (LH2) engine.
  8. Connect the PCV fresh air tube to the left camshaft cover.
  9. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .