Circuit Description
The instrument panel module (IPM) is the power mode master and the remote control door lock receiver (RCDLR) is the backup power mode master. Both modules receive information regarding ignition mode switch position from the ignition mode switch. IPM receives ignition mode switch position data through the IPM ignition mode data signal circuit.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC B1380 Device Ignition ACCESSORY Circuit
DTC Symptom | DTC Symptom Descriptor |
|---|---|
59 | Component Protection Time-Out |
Conditions for Running the DTC
Voltage supplied to the module is in the normal operating voltage range of 9-16 volts.
Conditions for Setting the DTC
The IPM sets the code if it detects that the OFF/ACC contact of the ignition mode switch is closed for more than 30 seconds.
Action Taken When the DTC Sets
The IPM does not react to switch inputs of equal or lower priority until condition is cleared.
Conditions for Clearing the DTC
| • | A current DTC clears when the malfunction is no longer present. |
| • | A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction. |
Diagnostic Aids
The following can cause the code to set as history:
| • | An intermittent problem of the ignition mode switch |
| • | The ACC/OFF button of the ignition mode switch was pressed for more than 30 seconds. |
Step | Action | Values | Yes | No |
|---|---|---|---|---|
Schematic Reference: Power Distribution Schematics Connector End View Reference: Master Electrical Component List | ||||
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | |
2 | Is the DTC B1380 set as current? | -- | Go to Step 3 | Go to Diagnostic Aids |
3 |
Do the values measured toggle from one to the other specified values? | 0/270 ohms | Go to Step 6 | Go to Step 4 |
4 | Inspect for poor connections and terminal tension at the harness connector of the ignition mode switch. Refer to Testing for Intermittent Conditions and Poor Connections . Did you find and correct the condition? | -- | Go to Step 8 | Go to Step 5 |
5 | Replace the ignition mode switch. Refer to Ignition and Start Switch Replacement . Did you complete the replacement? | -- | Go to Step 8 | -- |
6 |
Did you find and correct the condition? | -- | Go to Step 8 | Go to Step 7 |
7 | Replace the IPM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | -- | Go to Step 8 | -- |
8 |
Does the DTC reset? | -- | Go to Step 3 | System OK |
