Tools Required

J 36796 Clip Zip Clip Removal Tool

1. Lower the window.



2. Remove the door bezel trim cover.



3. Insert a flat-bladed tool at the bottom of the trim cover flap and pry up to access the screws.



4. Remove the door trim panel screws.



5. Use the J 36796 to release the retainers (1) from around the outside edges of the door trim panel.
6. Slide the door trim panel upwards to release it from the door.
7. Using a small flat-bladed tool, disconnect the door handle cables.

1. Slide the electrical connector (2) into position on the water deflector.
2. Connect the door handle cables.
3. Align the alignment datums (1) and the electrical connector with the door.



4. Install the door trim panel by applying pressure around the door trim panel to secure the retainers (1) to the door.

Notice: Refer to Fastener Notice in the Preface section.




5. Install the door trim panel screws.

Tighten
Tighten the screws to 1 N·m (9 lb in).




6. Fold the trim cover flap down.