Schematic Reference: Outside Rearview Mirror Schematics

Connector End View Reference: Power Door Systems Connector End Views

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

Verify that the Heated Mirrors Inoperative - One complaint is present.

Does the heated mirrors system operate as described in the Description and Operation?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Turn OFF the ignition.
2. Disconnect the C 4 harness connector at the door control module associated with the inoperative heated mirror.
3. Ensure that all other harness connectors to the door control module remain connected.
4. Connect a test lamp between the mirror heating element supply voltage circuit and the mirror heating element low reference circuit at the door control module pins.
5. Turn ON the ignition, with the engine OFF.

Does the test lamp illuminate?

Go to Step 9

Go to Step 4

While observing the test lamp, command the mirrors to heat by turning ON the rear window defroster.

Does the test lamp illuminate?

Go to Step 5

Go to Step 9

1. Turn OFF the ignition.
2. Carefully remove the mirror face of the mirror that does not heat. Refer to Mirror, Mirror Face Replacement - Front Door .
3. Disconnect the heated mirror harness connector from the mirror face.
4. Connect a test lamp between the mirror heater circuits of the harness connector.
5. Turn ON the ignition, with the engine OFF.

Does the test lamp illuminate?

Go to Step 7

Go to Step 6

While observing the test lamp, command the mirrors to heat by turning ON the rear window defroster.

Does the test lamp illuminate?

Go to Step 8

Go to Step 7

Inspect for poor connections at the harness connector of the inoperative heated rear view mirror. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 12

Inspect for poor connections at the harness connector of the inoperative heated mirror face. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 10

Inspect for poor connections at the C 4 harness connector of the door control module associated with the inoperative outside rear view mirror. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 11

Replace the inoperative heated rear view mirror face. Refer to Mirror, Mirror Face Replacement - Front Door .

Did you complete the replacement?

Go to Step 13

--

Important: Perform the setup procedure for the replacement door module. Refer to Door Control Module Programming and Setup in Programming and Setup.

Replace the door control module associated with the inoperative outside rear view mirror. Refer to Control Module References in Computer/Integrating Systems.

Did you complete the replacement?

Go to Step 13

--

Replace the inoperative heated rear view mirror. Refer to Mirror, Mirror Face Replacement - Front Door .

Did you complete the replacement?

Go to Step 13

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2