For 1990-2009 cars only
Removal Procedure
- Cycle the sunroof window to the vent position.
- Slide the sunshade rearward.
- Disconnect the sunroof panel side opening closeout covers (5) from the sunroof window clips (1,3,4) in order to access the window screws (2,6).
- Tape the sunroof panel side opening closeout covers in a downward position.
- Remove the sunroof window screws (1) on both sides.
- Lift the sunroof window (3) from the sunroof opening.
Notice: In order to prevent damage to the paint, mask the roof panel in front of the sunroof opening using masking tape and paper.
Important: Be careful not to scratch the roof surface or the sunroof window.
Installation Procedure
- Position the sunroof window (3) into the opening, with the window trade mark pointing rearward.
- Install the sunroof window screws (1).
- Finger tighten the screws, do not tighten.
- Carefully close the sunroof window from the vent position to the full closed position.
- Adjust the sunroof window. Refer to Sunroof Window Height and Opening Fit Adjustment .
- Connect the sunroof panel side opening closeout covers (2) to the sunroof window clips.
- Snap the sunroof panel side opening closeout covers into the sunroof window retention clips.
- Close the sunshade.
- Cycle the sunroof window to ensure proper operation and fit.
