Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Headlamp Washer Solvent Container Replacement

Preliminary Procedures

1. Lift and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
3. Remove the air deflector assembly. Refer to Front Air Deflector Replacement .

1

Front Compartment Sight Shield Retainer (Qty: 6)

2

Front Compartment Sight Shield Assemblies

3

Front Bumper Fascia Extension Retainer (Qty: 11)

4

Front Bumper Fascia Extension

Tip
Right side only

5

Front Bumper Fascia Assembly

Refer to Front Bumper Fascia Replacement .

6

Headlamp Assembly

Refer to Headlamp Replacement .

Tip
Right side only

7

Washer Bottle Cap

8

Windshield Washer Solvent Container Bolt (Qty: 3)

Tighten
9 N·m (80 lb in)

9

Windshield Washer Solvent Container Assembly

Windshield Washer Pump Replacement

Preliminary Procedures

1. Lift and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
3. Remove the air deflector assembly. Refer to Front Air Deflector Replacement .

3

Front Bumper Fascia Extension Retainer (Qty: 11)

4

Front Bumper Fascia Extension

Tip
Right side only

10

Windshield Washer Pump Assembly

Tip

1. Disconnect washer hose and drain washer solvent.
2. Disconnect electrical connector.

11

Windshield Washer Pump Grommet

Windshield Washer Solvent Level Switch Replacement

Preliminary Procedures

1. Lift and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the air deflector assembly. Refer to Front Air Deflector Replacement .

12

Windshield Washer Solvent Level Switch Seal

13

Windshield Washer Solvent Level Switch

Tip

1. Drain washer fluid and refill when finished with replacement.
2. Disconnect electrical connector and reconnect when finished with replacement.
3. Using two flat bladed tools, pry outward the washer solvent container level sensor switch from the solvent container.
4. Use equal inward pressure to seat the level sensor switch into the seal.