Steering Column Lock Control Module Replacement Domestic Vehicles

1. Remove the knee bolster. Refer to Driver Knee Bolster Bracket Replacement .



2. Disconnect the electrical connectors to the steering column module (1).
3. Loosen the retaining screw on the steering column control module. Slide the control module out of the retaining bracket.

Notice: Refer to Fastener Notice in the Preface section.




1. Install the control module (1) to the steering column and tighten the retaining screw.

Tighten
Tighten screw to 5 N·m (44 lb in).

2. Connect the electrical connectors on the steering column control module.
3. Install the knee bolster. Refer to Driver Knee Bolster Bracket Replacement .
4. Program the steering column control module. Refer to Steering Column Lock Control Module Programming and Setup .

Steering Column Lock Control Module Replacement Export Vehicles

1. Remove the steering column. Refer to Steering Column Replacement.



2. Disconnect the electrical connectors from the steering column lock control module.



3. Depress the locking tabs and remove the steering column lock control module from the support bracket.

1. Install the steering column lock control module to the support bracket.



2. Connect the electrical connectors to the steering column lock control module.
3. Install the steering column. Refer to Steering Column Replacement.
4. Program the steering column control module. Refer to Steering Column Lock Control Module Programming and Setup .