Callout
| Component Name
|
|
Notice: Refer to Fastener Notice in the Preface section. Fastener Tightening Specifications:
Refer to
Fastener Tightening Specifications
.
Preliminary Procedures
- Remove the cross vehicle brace. Refer to
Cross Vehicle Brace Replacement
.
- Remove the engine oil fill cap.
- Remove the power steering reservoir cap.
|
1
| Engine Sight Shield
Tip
Remove the engine sight shield by lifting straight up. |
2
| Supercharger Inlet Duct Assembly
Tip
Only remove the front section of the supercharger inlet duct assembly. Refer to
Supercharger Inlet Duct Assembly Replacement
. |
3
| Ignition Coil Assembly Cover
Tip
Remove the ignition coil assembly cover by lifting straight up. |
4
| Ignition Coil Assembly Bolts (Qty: 2)
Tip
| • | Do not remove these fasteners if replacing an individual ignition coil. If replacing an individual ignition coil, proceed to callout 7. |
| • | Disconnect the main electrical connector from the coil assembly. |
Tighten
10 N·m (89 lb in) |
5
| Ignition Coil Assembly Studs (Qty: 2)
Tip
Do not remove these fasteners if replacing an individual ignition coil. If replacing an individual ignition coil, proceed to callout 7.
Tighten
10 N·m (89 lb in) |
6
| Ignition Coil Assembly
Tip
Ensure that the spark plug seals, callout 9, are in place during reassembly. |
7
| Ignition Coil Bolt (Qty: 4)
Tighten
10 N·m (89 lb in) |
8
| Ignition Coil (Qty: 4)
Tip
| • | Disconnect the electrical connector from the ignition coil. |
| • | Ensure that the spark plug seals, callout 9, are in place during reassembly. |
|
9
| Spark Plug Seal (Qty: 4)
|
