GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2007 🢒 STS 🢒 Engine 🢒 Engine Mechanical - 4.4L 🢒 Oil Pan Replacement

Removal Procedure

    Object Number: 1213854 Size: SH
  1. Install the engine support fixture. Refer to Engine Support Fixture .
  2. Drain the engine oil. Refer to Engine Oil and Oil Filter Replacement .
  3. Remove the front frame. Refer to Front Frame Replacement .
  4. Disconnect the electrical connector from the engine oil level sensor.
  5. Remove the engine oil level sensor from the oil pan.

    6. Object Number: 1535942 Size: SH
  6. Remove the oil pan bolts.
  7. Remove the oil pan.
  8. Drill out the oil pan gasket rivets.

    9. Object Number: 1351925 Size: SH
  9. Remove and discard the oil pan gasket.
  10. Clean and inspect the oil pan. Refer to Oil Pan Cleaning and Inspection .

Installation Procedure

    Object Number: 1535942 Size: SH
  1. If required, install a new oil pan gasket. It is not necessary to rivet the new oil pan gasket to the oil pan.
  2. Position the oil pan onto the lower crankcase.

    3. Object Number: 1348913 Size: SH
  3. The oil pan must be held flush to 0.50 mm (0.020 in) forward of the rear face of the engine block.

    4. Object Number: 1577253 Size: SH
  4. Place oil pan fasteners in location as shown:
    5. • Short length bolt (420)
    • Medium length bolt (421)
    • Long length bolt (422)

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1348914 Size: SH
  5. Install the oil pan bolts. Tighten the bolts in the sequence shown.

    6. Tighten

    1. First pass--Tighten the bolts to 15 N·m (11 lb ft).
    2. Final pass--Tighten the bolts to 25 N·m (18 lb ft).

    Object Number: 1213854 Size: SH
  6. Install the engine oil level sensor into the oil pan.

    7. Tighten
    Tighten the sensor to 10 N·m (89 lb in).

  7. Connect the electrical connector to the engine oil level sensor.
  8. Install the front frame. Refer to Front Frame Replacement .
  9. Fill the engine oil. Refer to Engine Oil and Oil Filter Replacement .
  10. Remove the engine support fixture. Refer to Engine Support Fixture .
  11. Inspect for oil leaks after engine start up.