Left Side Harness Connections
- Disconnect the engine wiring harness
from the oil level switch/temperature sensor.
- Disconnect the engine wiring harness from the air conditioner compressor.
- Disconnect the engine wiring harness from the oil pressure sensor.
- Disconnect the engine wiring harness
from the supercharger charge air bypass regulator solenoid valve.
- Disconnect the engine wiring harness from the left camshaft
position sensors.
- Disconnect the engine wiring harness
from the left camshaft position actuators.
- Disconnect the engine wiring harness from the throttle body.
- Disconnect the engine wiring harness from the evaporative emissions (EVAP) canister
purge solenoid.
- Disconnect the engine wiring harness from the left coil assembly harness.
- Disconnect the engine wiring harness
from the left camshaft cover.
- Disconnect the engine wiring harness from the left side fuel injectors.
- Disconnect the engine wiring harness starter connector from the starter wiring
harness.
- Remove the left rear engine harness
bracket bolt and nut.
- Remove the left rear engine harness bracket.
Right Side Harness Connections
- Remove the generator positive battery
cable nut.
- Remove the generator positive battery cable.
- Disconnect the engine wiring harness from the generator.
- Disconnect the engine wiring harness clips from the generator.
- Disconnect the engine wiring harness
from the right camshaft position sensors.
- Disconnect the engine wiring harness
from the right camshaft position actuators.
- Disconnect the engine wiring harness
from the intake air temperature (IAT) sensor 2.
- Disconnect the engine wiring harness
from the (1) supercharger inlet absolute pressure sensor, (2) barometric pressure (BARO) sensor, (3) manifold absolute pressure (MAP) sensor.
- Disconnect the engine wiring harness from the right coil assembly harness.
- Disconnect the engine wiring harness
from the right camshaft cover.
- Disconnect the engine wiring harness from the right side fuel injectors.
- Disconnect the engine wiring harness
from the engine coolant temperature (ECT) sensor at the rear of the right cylinder head.
- Disconnect the engine wiring harness
from the knock and crankshaft position sensor wiring harness.
- Remove the right side engine harness
bracket bolts.
- Remove the right side rear engine harness bracket.
- Remove the right rear engine harness bracket bolt.
- Remove the right rear engine harness bracket.
- Remove the engine wiring harness from the engine block.