For 1990-2009 cars only
Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Disconnect the fuel tank pressure sensor electrical connector (1).
- Remove the fuel tank pressure sensor from the evaporative emission (EVAP) canister.
Important: There are alignment features on the canister, however, there are no locking tabs on the sensor/canister. The sensor is held into the canister by the tight fit of the multi-lip seal.
Installation Procedure
- Install the fuel tank pressure sensor to the EVAP canister until fully seated.
- Connect the fuel tank pressure sensor electrical connector (1).
- Lower the vehicle.
Important: There are alignment features on the canister, however, there are no locking tabs on the sensor/canister. The sensor is held into the canister by the tight fit of the multi-lip seal.
