Removal Procedure
- Run the window to the full closed position.
Caution: Refer to Glass and Sheet Metal Handling Caution in the Preface section.
Caution: Refer to Express Window Down Caution in the Preface section.
- Remove the door trim panel. Refer to
Front Side Door Trim Panel Replacement
.
- Remove the water deflector. Refer to
Front Side Door Water Deflector Replacement
.
- Tape the window in the closed position.
- Loosen the window clamp nuts 4 revolutions.
- Connect the door trim panel electrical connector.
- Using the power window switch, lower the window regulator to separate the window from the clamps.
- Remove the tape.
- Remove the window by tilting the window forward then pulling the window up and out of the door.
Installation Procedure
Important: The window regulator should be at least 1/2 way down before installing the window.
- Position the window down into the door.
- Locate the window into the 2 window regulator clamps.
Important: Start the vehicle to ensure maximum power to the window motor. This is required in order to fully seat the window for adjustment.
- Start the vehicle.
Notice: Refer to Fastener Notice in the Preface section.
- Using the power window switch, raise the window to the fully closed position.
Tighten
Tighten the window clamp nuts to 11 N·m (98 lb in).
- Inspect for proper window operation and a tight seal.
- Shut off the vehicle.
- Install the water deflector. Refer to
Front Side Door Water Deflector Replacement
.
- Install the door control module. Refer to
Door Control Module Replacement
.
- Install the door trim panel. Refer to
Front Side Door Trim Panel Replacement
.