1

Front Compartment Sight Shield Retainer (Qty: 6)

2

Front Compartment Sight Shield Assembly

Tip
The center sight shield needs to be removed, the side sight shields only need to be loosened.

3

Front Fascia Assembly Retainer (Qty: 4)

Tip

1. Remove the 4 retainers to loosen the fascia assembly.
2. Pull the front fascia assembly forward to gain access to the cruise control module nuts.

4

Cruise Control Module Assembly

Notice: Refer to Fastener Notice in the Preface section.

Tip

1. Loosen the nuts that hold the cruise control module into the T-slots on the tie bar.
2. Disconnect the electrical connector.
3. Slide the module out of the T-slots on the bracket.
4. Replace the module by sliding the assembly into the T-slots on the bracket and tighten.
5. Verify proper alignment of the module. Refer to Control Module References for programming and setup information.

Tighten
9 N·m (80 lb in)