GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2007 🢒 STS 🢒 Body Hardware and Trim 🢒 Interior Trim and Paneling 🢒 Center Pillar Garnish Molding Replacement

Removal Procedure

    Caution: Refer to SIR Caution in the Preface section.

    Caution: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.

  1. Disable the SIR system. Refer to SIR Disabling and Enabling.
  2. Remove the front carpet retainers. Refer to Front Carpet Retainer Replacement .
  3. Remove the rear carpet retainers. Refer to Rear Carpet Retainer Replacement .

    4. Object Number: 708056 Size: SH
  4. Carefully pull outward at the bottom of the pillar trim in order to use the J 38778 in order to release the 3 lower retainer clips.
  5. Pull outward on the upper portion of the pillar trim in order to release the sheet metal retainer clips from the lock pillar.
  6. Slide the pillar trim inward and downward in order to release the top locking tab from between the sheet metal and the headliner.
  7. Remove the center pillar trim.
  8. Replace the retainer clips if broken or damaged.

Installation Procedure

    Object Number: 708056 Size: SH
  1. Position the top of the locking tab to the slot in the sheet metal under the headliner.
  2. Push upward in order to secure.
  3. Position the upper trim locating tabs to the metal clips in the lock pillar.
  4. Position the 3 plastic retainers to the holes in the lock pillar.
  5. Push inward beginning at the top of the pillar and working downward to the floorpan in order to secure the center pillar trim.
  6. Install the rear carpet retainers. Refer to Rear Carpet Retainer Replacement .
  7. Install the front carpet retainers. Refer to Front Carpet Retainer Replacement .
  8. Enable the SIR system. Refer to SIR Disabling and Enabling.