1. Remove the engine sight shield . Refer to Intake Manifold Sight Shield Replacement .
2. Partially drain the engine cooling system. Refer to Cooling System Draining and Filling .
3. Remove the radiator hose from the water outlet housing. Position the hose aside.
4. Disconnect the actuator solenoid electrical connector.
5. Remove the right intake camshaft position (CMP) actuator solenoid bolts.
6. Remove the right intake CMP actuator solenoid.

Important: The CMP actuator solenoid must be precisely aligned to the CMP actuator oil control valve on the end of the camshaft. This is accomplished with an alignment pin. Failure to align the CMP actuator solenoid to the CMP actuator oil control valve can lead to poor engine performance and engine component damage.

To allow for CMP actuator solenoid to CMP actuator oil control valve alignment, DO NOT install the NEW CMP actuator solenoid alignment plugs at this time.

1. Make an alignment pin from drill rod 15/64 inch diameter and at least 50 mm (1.97 in) long.
2. If necessary remove the black alignment plug on the actuator and verify that the alignment pin will pass through the CMP actuator solenoid alignment hole.
3. Verify that the alignment pin will fit into the alignment hole in the CMP actuator oil control valve.
4. Apply a 2 mm (0.079 in) bead of RTV GM P/N 12378521 (Canadian P/N 88901148) around the flange of the CMP actuator solenoid.
5. Install the CMP actuator solenoid over the oil control valve.
6. Install the alignment pin through the solenoid alignment hole and into the oil control valve alignment hole.

Notice: Refer to Fastener Notice in the Preface section.

7. With the alignment pin in place, install the CMP actuator solenoid bolts.

Tighten
Tighten the CMP actuator solenoid bolts to 8 N·m (71 lb in).

8. Remove the alignment pin.
9. Install a NEW CMP actuator solenoid plug.
10. Connect the electrical connector to the actuator solenoid.
11. Install the radiator hose to the water outlet housing.
12. Install the engine sight shield. Refer to Intake Manifold Sight Shield Replacement .
13. Fill the engine cooling system. Refer to Cooling System Draining and Filling .