The Check Washer Fluid message is controlled by the instrument panel cluster using an input from the washer fluid level switch. The washer fluid level signal circuit is supplied ignition voltage through a resistor then monitored within the instrument cluster. The washer fluid level switch is normally open so the instrument cluster detects ignition voltage on the washer fluid level signal circuit whenever the washer fluid level is not low. When the washer fluid reaches the point where the driver should be informed that the washer fluid is low, the washer fluid level switch closes. When the washer fluid level switch is closed the washer fluid level signal circuit voltage is pulled low, and the instrument panel displays the Check Washer Fluid message on the driver information center. In order to prevent the Check Washer Fluid message from being displayed while sloshing is occurring in the washer fluid container, the instrument cluster is programed with a 1 minute delay before changing states of the Check Washer Fluid message during an ignition cycle.

Schematic Reference

Wiper/Washer Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Wiper/Washer System Description and Operation

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

Verify the windshield washer fluid level is above the minimum level.

1. Ignition OFF, disconnect the harness connector at the washer fluid level switch.
2. Test for less than 1 ohm of resistance between the ground circuit terminal A and ground.

⇒	If greater than the specified range, test the ground circuit for an open/high resistance.

3. Ignition ON. Verify the check washer fluid message is not displayed on the driver information center (DIC).

⇒	If the check washer fluid message is displayed on the driver information center, test the signal circuit terminal B for a short to ground. If the circuit tests normal, replace the IPC.

4. Install a 3A fused jumper wire between the signal circuit terminal B and ground. Verify the check washer fluid message is displayed on the driver information center (DIC).

⇒	If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the IPC.

5. If all circuits test normal, test or replace the washer fluid level switch.

1. Ignition OFF, disconnect the harness connector at the washer fluid level sensor.
2. Washer fluid level switch open, test for infinite resistance between the signal terminal B and the ground terminal A.

⇒	If not the specified value, replace the washer fluid level sensor.

3. Washer fluid level switch closed, test for less than 2 ohms of resistance between the signal terminal B and the ground terminal A.

⇒	If not within the specified range, replace the washer fluid level sensor.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.