Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Exhaust LP1, LY7

1. Turn the ignition OFF.

Important: Do not disconnect the power steering fluid lines/hoses from the reservoir.

2. Remove the power steering fluid reservoir bolts and reposition the power steering fluid reservoir in order to provide access. Refer to Remote Power Steering Fluid Reservoir Replacement .



3. Remove the camshaft position (CMP) actuator valve electrical connector.



4. Remove the CMP actuator valve bolt.
5. Remove the CMP actuator valve.
6. Inspect the CMP actuator valve seal for damage and replace as necessary.

1. Inspect the CMP actuator valve seal for damage. Replace the seal if necessary.



2. Install the CMP actuator valve.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the CMP actuator valve bolt.

Tighten
Tighten the CMP actuator valve bolt to 10 N·m (89 lb in).




4. Install the CMP actuator valve electrical connector.
5. Install the power steering fluid reservoir. Refer to Remote Power Steering Fluid Reservoir Replacement .