For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C047A 08: Electric Steering Motor Position Sensor Circuit Signal InvalidCircuit/System Description
The power steering control module (PSCM) actively monitors the steering actuator sensor circuits.
Conditions for Running the DTC
Engine running.
Conditions for Setting the DTC
| • | The actuator sensor is out of position when the lock is ON and the ignition is OFF. |
| • | The actuator sensor is out of position when the lock is OFF and the ignition is ON. |
| • | The actuator sensor rotation is out of position when the lock is ON and the ignition is ON or OFF. |
| • | The lock solenoid voltage is greater then 3 volts when the lock is ON and the relay is ON. |
Action Taken When the DTC Sets
| • | Active Steering is disabled. |
| • | SERVICE STEERING SYS and/or STABILITY SECURE MODE is displayed on the DIC. |
Conditions for Clearing the DTC
| • | A current DTC will clear on the next malfunction free ignition cycle. |
| • | A history DTC will clear after 100 consecutive malfunction free ignition cycles. |
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Active Front Steering Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Replace the steering actuator. Operate the vehicle within the Condition for Setting the DTC. Verify DTC C047A 08 does not reset.
| ⇒ | If the DTC resets, replace the PSCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for PSCM replacement, setup, and programming |
