| Table 1: | Power Steering Control Module Scan Tool Data Parameters |
| Table 2: | Power Steering Control Module Scan Tool Output Controls |
Parameter | System State | Expected Value | Description |
|---|---|---|---|
Operating Conditions: Ignition ON | |||
AFS Actuator Angle | -- | Varies | This displays °. This is the current angle of the active front steering (AFS) actuator. |
AFS Heat Protection | -- | Varies | The scan tool displays Active or Inactive. This is the state of the active front steering (AFS) heat protection. |
AFS Lock Solenoid | -- | Unlocked | The scan tool displays Locked or Unlocked. This is the state of the active front steering (AFS) lock solenoid. |
AFS Motor Command | -- | Varies | This displays %. This is the active front steering (AFS) motor percentage. |
PSCM Centered | -- | Yes | The scan tool displays Yes or No. Yes is displayed if the power steering control module (PSCM) is centered. |
Steering Wheel Sensor Signal | -- | Valid | The scan tool displays Valid or Invalid. This is the state of the steering wheel sensor signal. |
TCM Status Signal | -- | Valid | The scan tool displays Valid or Invalid. This is the state of the transmission control module (TCM) signal. |
VSCM Veh. Spd. Signal | -- | Valid | The scan tool displays Valid or Invalid. This is the state of the vehicle stability control module (VSCM) vehicle speed signal. |
Output Control | Description |
|---|---|
Actuator Removal Procedure | This output control is used to remove an actuator. |
New Actuator Setup Procedure | This output control is used to setup a new actuator. |
PSCM Calibration Procedure | This output control is used to calibrate a power steering control module (PSCM). |
