Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C1002 00: Distance Sensing Cruise Control Module Range/PerformanceCircuit/System Description
The forward looking sensor (FLS) has the exclusive function of detecting, tracking and classifying targets within its specified field of view. The FLS has the ability to detect and react to objects of interest in its detection zone and is critical to the proper operation of the adaptive cruise control (ACC) system. When the distance sensing cruise control module (DSCC) detects that the FLS is out of alignment, DTC C1002 sets.
Conditions for Running the DTC
| • | The ignition is ON. |
| • | The cruise switch is ON. |
Conditions for Setting the DTC
| • | The DSCC module detects there is 3.9 degrees of skew or error of the FLS. |
| • | The vehicle speed is at or greater than 40.2 km/h (25 mph). |
Actions Taken When the DTC Sets
| • | Loss of adaptive cruise control (ACC) function. |
| • | Service Radar Cruise message is displayed in the driver information center (DIC). |
Conditions for Clearing the DTC
| • | The condition responsible for setting the DTC no longer exists. |
| • | A history DTC will clear after 40 malfunction-free ignition cycles have occurred. |
Diagnostic Aids
An FLS radar out of alignment condition may be as a result of tampering with the DSCC module mounting structures/brackets or the adjuster settings. An out of alignment condition may also be a result of damage to the front section vehicle or the DSCC module.
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Cruise Control Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Special Tools
BO-47670 Adaptive Cruise Control (ACC) Radar Alignment Tool
Circuit/System Testing
- Align the FLS radar. Refer to Distance Sensing Cruise Control Aiming.
- Road test the vehicle and ensure the ACC system functions normally and DTC C1002 does not set. Refer to Cruise Control Description and Operation.
| ⇒ | If alignment cannot be achieved within the limits of the available adjustment, inspect the mounting structures and brackets for damage or tampering and repair as necessary to achieve proper alignment. |
| ⇒ | If DTC C1002 resets, replace the FLS radar. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for DSCC module replacement, setup, and programming
