Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category |
DTC Descriptor
DTC B3089: Intrusion Sensor Armed Signal CircuitDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
B+ | B3089 | B3089 | -- | -- |
Inclination/Intrusion Sensor Armed Signal | B2923, B3089 | B2923, B3089 | B2923, B3089 | -- |
Inrusion Sensor Alarm Signal | B3089 | B3089 | B3089 | -- |
Circuit/System Description
When the Content Theft Deterrent (CTD) system arms and enables the intrusion sensor, the Rear Integration Module (RIM) receives a power-up acknowledgement from the intrusion sensor via the intrusion sensor armed signal circuit.
Conditions for Running the DTC
| • | CTD System is armed |
| • | Intrusion sensor is enabled |
Conditions for Setting the DTC
The RIM does not receive the power-up acknowledgement from the intrusion sensor
Action Taken When the DTC Sets
The RIM will ignore all inputs from the intrusion sensor for the remainder of the CTD System arming cycle
Conditions for Clearing the DTC
A current DTC will clear when the RIM receives a power-up acknowledgement from the intrusion sensor during the next CTD system arming cycle
Reference Information
Schematic Reference
Theft Deterrent System Schematics
Connector End View Reference
Description and Operation
Content Theft Deterrent (CTD) Description and Operation
Electrical Information Reference
| • | Circuit Testing |
| • | Wiring Repairs |
Scan Tool Reference
Refer to Control Module References for Scan Tool Information
Circuit/System Verification
- Ignition OFF, disconnect the X2 harness connector at the RIM. Disconnect the harness connector at the intrusion sensor.
- Verify a test lamp does not illuminate between the signal circuit terminal C at the intrusion sensor and B+.
- Test for less than 2 ohms between the signal circuit terminal C at the intrusion sensor and the signal circuit terminal 11 at the RIM X2 harness connector.
- Ignition ON, verify a test lamp does not illuminate between the signal circuit terminal C at the intrusion sensor and ground.
- If all circuits test normal, test or replace the intrusion sensor.
| ⇒ | If the test lamp illuminates, test the signal circuit for a short to ground. |
| ⇒ | If greater than the specified range, test the signal circuit for an open/high resistance. |
| ⇒ | If the test lamp illuminates, test the signal circuit for a short to B+. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure
