• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
---|---|---|---|---|
Antenna Signal - Left Front | B1283 00 | B1283 00 | -- | -- |
Antenna Signal - Left Rear | B1286 00 | B1286 00 | -- | -- |
Antenna Signal - Right Front | B1284 00 | B1284 00 | -- | -- |
Antenna Signal - Right Rear | B1285 00 | B1285 00 | -- | -- |
The TV antenna signal circuits consists of 4 individual coaxial cables that carry the TV signal information received by the TV antenna through the TV antenna amplifier to the TV antenna module.
• | Ignition ON. |
• | Battery voltage must be between 9-16 volts. |
The TV antenna module detects a open or short to ground on one or more of the 4 TV antenna coax cables for 20 seconds.
The TV antenna module disables all 4 coax cables when a short to ground is detected. When the TV antenna detects an open/high resistance in one or more TV antenna coax inputs, the unaffected TV antenna coax inputs will continue to operate.
• | The condition responsible for setting the DTC no longer exists. |
• | The DTC clears after the TV function has been cycled OFF then ON. |
Radio/Navigation System Schematics
Radio/Audio System Description and Operation
Control Module References for scan tool information
⇒ | If greater than the specified range, replace the antenna coax cable. |
⇒ | If greater than the specified range, replace the antenna coax able. |
⇒ | If less than the specified range, replace the antenna coax cable. |
⇒ | If less than the specified value, replace the TV antenna module. |
⇒ | If greater than the specified range, replace the TV antenna coax cable. |
⇒ | If greater than the specified range, replace the TV antenna coax able. |
⇒ | If less than the specified range, replace the TV antenna coax cable. |
⇒ | If less than the specified value, replace the TV antenna amplifier. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.