GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2009 🢒 STS 🢒 Engine 🢒 Engine Controls and Fuel - 4.6L (LH2) 🢒 Rear Suspension Bracket Replacement

Removal Procedure

    Object Number: 2000460 Size: SH
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Support the lower control arm with a jack stand.
  3. Remove the suspension bracket bolts (6).

    4. Note: 

       • If removing the suspension bracket, but not servicing the suspension bracket, DO NOT remove the bolt (1).
       • If lowering the rear suspension cradle or if servicing the fuel filter, only remove the suspension bracket bolts (6).

  4. Remove the rear suspension brace bolt (3).
  5. Remove the suspension bracket (5)  from the vehicle.
  6. Remove the nut (4) and the bolt (1) for the rear suspension brace (2), if needed.
  7. Remove the rear suspension brace (2) from the rear suspension bracket (5), if needed.

Installation Procedure

    Object Number: 2000460 Size: SH
  1. Position the rear suspension brace (2) in the rear suspension bracket (5), if needed.
  2. Install the rear suspension brace nut (4) and the bolt (1), if needed. Hand tighten the nut (4) and the bolt (1).
  3. Position the rear suspension bracket (5) on the vehicle.

    4. Caution: Refer to Fastener Caution in the Preface section.

  4. Install the rear suspension bracket mounting bolts (6) and tighten to 58 N·m (43 lb ft).
  5. Install the rear suspension brace mounting bolt (3) and tighten to 85 N·m (63 lb ft).
  6. Tighten the rear suspension brace bolt (1) and tighten to 160 N·m (118 lb ft).
  7. Remove the jack stand from the lower control arm.
  8. Remove the support and lower the vehicle.