Throttle Body Assembly Replacement LP1, LY7

1. Turn the ignition OFF.
2. Remove the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement.

Caution: Refer to Disengaging Connectors Caution in the Preface section.




3. Remove the throttle body electrical connector.



4. Unlock and reposition the wiring harness conduit.



5. Remove the throttle body bolts.
6. Remove the throttle body and gasket.

1. Carefully clean the throttle body mounting surfaces of any gasket and/or seal material.



2. Install the throttle body and NEW gasket.

Caution: Refer to Fastener Caution in the Preface section.

3. Install the throttle body bolts and tighten to 10 N·m (89 lb in).



4. Install the wiring harness conduit.



5. Install the throttle body electrical connector.
6. Install the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement.
7. Perform the throttle learn procedure. Refer to Throttle Learn.
8. Use the scan tool to clear all DTCs.