GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2009 🢒 STS 🢒 Diagnostic Navigation 🢒 Programming and Setup 🢒 Brake Pedal Position Sensor Replacement

Removal Procedure
  1. Remove the driver side instrument panel (I/P) insulator closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side.

    2. Object Number: 1233592 Size: SH
  2. Remove the bolt (1) securing the brake pedal position switch to the brake panel bracket.
  3. Remove the switch.

Installation Procedure

    Object Number: 1233592 Size: SH
  1. Connect the electrical connector on the switch.
  2. Align the brake panel position switch to the stud (3).

    3. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the bolt (1) securing the brake panel position switch to the brake panel bracket and tighten to 9 N·m (80 lb in).
  4. Install the driver side I/P insulator closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side.
  5. Recalibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration.