GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2009 🢒 STS 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Knock Sensor 2 Replacement

Removal Procedure

    Object Number: 1614621 Size: SH
  1. Remove the supercharger assembly. Refer to Supercharger Replacement.

    2. Object Number: 1284306 Size: SH
  2. Disconnect the knock sensor (KS) electrical connector (3).
  3. Remove the KS bolt.
  4. Remove the KS (4).

Installation Procedure
  1. Thoroughly clean the mating surfaces of the KS and the engine block. The entire contact surface of the KS must lie directly on the engine block.

    2. Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 1284306 Size: SH

    Note: DO NOT use washers, spring washers, or toothed washers when installing the KS. Tighten the bolt to the proper torque.

  2. Install the KS (4) and bolt and tighten to 20 N·m (15 lb ft).

    3. Note: The KS wiring harness is held in place with several retaining clips.

  3. Ensure that the wiring harness is installed correctly.
  4. Connect the KS electrical connector (3).

    5. Object Number: 1614621 Size: SH
  5. Install the supercharger assembly. Refer to Supercharger Replacement.