Removal Procedure
Warning: Refer to SIR Warning in the Preface section.
- Disable the SIR coil. Refer to
SIR Disabling and Enabling.
- Remove the steering wheel from the column. Refer to
Steering Wheel Replacement.
- Remove the steering column from the vehicle. Refer to
Steering Column Replacement.
- Inspect the steering column for accident damage. Refer to
Steering Column Accident Damage Inspection.
- To remove the tilt drive motor assembly (2) perform the following procedure:
5.1. | Disconnect the connectors of the tilt drive motor assembly (2). |
5.2. | Remove the 2 TORX® head screws (3). |
5.3. | Remove the tilt drive motor assembly (2). |
5.4. | Pull off the potentiometer housing (1). |
- To remove the tilt cable assembly perform the following procedure:
6.1. | With locking pliers squeeze the white end of the tilt cable assembly to remove from the tilt drive motor assembly. |
6.2. | Pull the black end to separate the tilt cable assembly from the steering column. |
Installation Procedure
- Install the black end of the tilt cable assembly to the steering column.
- Install the white end of the tilt cable assembly to the tilt drive motor assembly.
- Snap on the potentiometer housing. (1).
- Install the tilt drive motor assembly (2) to the steering column.
Caution: Refer to Fastener Caution in the Preface section.
- Install 2 TORX® head screws (3) and tighten to
1.5 N·m (13 lb in).
Warning: Refer to SIR Inflator Module Coil Warning in the Preface section.
- Connect the connectors of the tilt drive motor assembly (2).
- Install the steering column into the vehicle. Refer to
Steering Column Replacement.
- Install the steering wheel onto the steering column. Refer to
Steering Wheel Replacement.
- Enable the SIR system. Refer to
SIR Disabling and Enabling.