Special Tools

For equivalent regional tools, refer to Special Tools

1. Place the engine flywheel in position on the crankshaft.
2. Install 2 NEW bolts in location at the top and bottom of the engine flywheel bolt pattern allowing the engine flywheel to hang in position.



3. Install the EN 46106 tool .

Caution: Refer to Fastener Caution in the Preface section.




4. Install the remaining NEW engine flywheel bolts.

•	Tighten the NEW engine flywheel bolts to 30 N·m (22 lb ft).

•	Tighten the NEW engine flywheel bolts an additional 45 degrees using the J 45059 meter .




5. Remove the EN 46106 tool .