GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2009 🢒 STS 🢒 Power and Signal Distribution 🢒 Data Communications 🢒 Vehicle Stability Control Module Replacement

Removal Procedure

    Object Number: 1906584 Size: SH
  1. Turn the ignition switch to the OFF position.
  2. Remove the left rear compartment side trim panel. Refer to Rear Compartment Trim Panel Replacement.
  3. Disconnect the stability control module electrical connectors.
  4. Release the stability control module from the module bracket locking tabs (1).

    5. Object Number: 1906585 Size: SH
  5. Lift the stability control module (1) from the bracket and remove the stability control module.

    6. Object Number: 1906586 Size: SH
  6. If necessary, remove the stability control module bracket nuts (1) and remove the bracket.

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 1906586 Size: SH
  1. If removed, install the stability control module bracket and the nuts (1).

    2. Tighten
    Tighten the nuts to 10 N·m (89 lb in).


    Object Number: 1906585 Size: SH
  2. Install the stability control module (1) to the bracket.

    3. Object Number: 1906584 Size: SH
  3. Press the stability control module into the module bracket locking tabs (1).
  4. Connect the stability control module electrical connectors.
  5. Install the left rear compartment side trim panel. Refer to Rear Compartment Trim Panel Replacement.
  6. Program the stability control module. Refer to Control Module References.
  7. Perform the Diagnostic System Check - Vehicle.