For 1990-2009 cars only
Removal Procedure
- Disable the SIR System. Refer to SIR Disabling and Enabling.
- Move the front seat forward in order to access the front seat track trim cover (1).
- Remove the seat track trim cover (1) from the seat track.
- Remove the seat track fasteners (1) from the seat track.
- Disconnect the seat electrical connectors (1).
- Use an awl or equivalent to release the seat belt from the seat. The hole to insert the awl is located on the outboard side of the seat (1).
- Remove seat belt from seat.
- Disconnect wire harness from seat bracket.
- With the aid of an assistant, remove the seat from the vehicle.
Warning: Refer to SIR Warning in the Preface section.
Note: Move seat to rear position and raise front of seat to gain access to seat electrical connectors.
Installation Procedure
- With the aid of an assistant, install the seat into the vehicle.
- Insert the front tabs (1) on the seat track into the floor.
- Connect the electrical connectors (1).
- Connect wire harness to seat bracket.
- Install the seat track fasteners (1) and tighten to 30 N·m (22 lb ft).
- Install the seat track trim covers (1).
- Install seat belt to seat.
- Enable the SIR System. Refer to SIR Disabling and Enabling.
Caution: Refer to Fastener Caution in the Preface section.
