GM Service Manual Online
For 1990-2009 cars only

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P0575: Cruise Control Switch Signal Circuit

Circuit/System Description

When a cruise control function switch is activated, the instrument panel module (IPM) detects a predetermined voltage signal. The IPM sends a serial data message to the engine control module (ECM) indicating the function that has been requested.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

    • The ECM receives an invalid cruise control switch status serial data message from the IPM.
    • This diagnostic runs continuously.

Actions Taken When the DTC Sets

    • The malfunction indicator lamp (MIL) will not illuminate.
    • The cruise control system is disabled.

Conditions for Clearing the DTC

    • The condition responsible for setting the DTC no longer exists.
    • A history DTC will clear after 40 malfunction-free ignition cycles have occurred.

Reference Information

Schematic Reference

Cruise Control Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Cruise Control Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

  1. Verify that DTC B3794 is not set.
  2. If the DTC is set, refer to DTC B3794.
  3. Road test the vehicle and attempt to engage the cruise control. Verify the cruise control system engages properly and the DTC P0575 is not set.
  4. If DTC resets, replace the IPM. Clear the DTC, road test the vehicle and attempt to engage the cruise control. If DTC resets, replace the ECM.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for ECM or IPM replacement, setup, and programming